The LC Billet Plug Wire Loom will keep your plug wire out of harms way of your header or exhaust manifold while adding a custom look to your engine. Please read complete instructions before installing your wire loom.

Installation:

• Remove stock wire holder clips from valve cover.
• Install your new Billet Loom on the valve cover. Place the spacer(s) between valve cover and loom on the forward mount post. Use the nylon washers between allen bolts and loom to prevent scratching.
• Position the plug wires over the loom. Install the isolators on your plug wires leaving them loose. Next place the isolators in the loom brackets and position the wires on the loom. Tighten the isolator allen bolts to prevent the wires from moving. Install nylock nuts on the bottom of isolator while holding the allen bolts tight.
• Polish with soft cloth to remove finger prints.

Hardware:
1   8mm x 1.25 x 25mm Stainless Button Head
1   8mm x 1.25 x 16mm Stainless Button Head
2   5/16 .032 Nylon Washer
3   Aluminum Spacer

Call our Tech Line in you have any questions on installation. 928-505-2501