This billet air filter adapter will provide the ability to run the K&N (or similar) 2” x 11” free flow cleanable air filter on the stock 2-barrel Asian Carburetor found on 81-95 22R engines¬.

Instructions: Remove the stock air filter and center filter stud from the carburetor. Using¬ a 6mm Nylock nut, install the new filter stud and tighten the nylock nut against carb body to hold the stud in place. For a dust proof seal, apply a small amount of silicone between the filter¬ adapter and the carb. Install air filter, flat washer and nut. Tighten enough to snug air filter¬ without over tightening.

Contents:
1 Billet Adapter
1 6mm x 100 x 5” Filter Stud
2 6mm x 100 Nylock Nut
1 6mm Flat Washers

Call our Tech Line in you have any questions on installation. 928-505-2501